Using gNappies – putting them together and putting them on

gNappies are great nappies – they’re incredibly slim fitting and look great on – but they do have a few idiosyncrasies that makes them not like any other cloth nappy that I’ve owned/seen. This is not a bad thing but does mean putting them together and putting them on is a bit different too – I thought a little run through might be useful for anyone considering using gNappies (or for anyone already using gNappies but struggling to get a good fit). gNappies come in three parts as shown above: the gPant, a cotton outer (not waterproof); the gPouch, a waterproof pouch to hold the absorbent layer; and the gCloth, the absorbent layer with a fleece top to keep baby comfy and hemp and cotton for absorbency. You can replace the gCloth with gRefills, which are a fully biodegradable, disposable option.

To put the nappy together the gPouch is first poppered into the gPant. This poppering makes it really easy to replace the pouch when you do a nappy change. It also makes the pouch more flexible within the nappy which helps the pouch keep a good seal (when it’s fitted properly!). The gCloth can then be laid in the pouch. The cloth is slightly larger than the pouch which causes the nappy to fold in half slightly – this is expected and makes sure the nappy fits without the cloth moving about and possibly escaping the pouch.

I tend to make up all our nappies at the same time – makes nappy changes a bit quicker. As we have twice as many pouch/cloth combos that gPants I also put the spares together so that I can change Eli into a clean gNappy and then snap in another pouch to the previous gPant. We’re all about saving ourselves a bit of time at the nappy changing station!

Right, so now the nappies have been put together, it’s time to put them onto a baby. The main points to remember when fitting a gNappy are:

  1. The ‘g’ logo is on the bum – yes this means that they do up around the back.
  2. The tabs must be done up straight and not too tight.
  3. The pouch edges must be within the crease of the baby’s leg – very important!
  4. Give the gPant a little tug at the back when you’ve finished the change.

Doing up the tabs

gNappy tabs do up at the back which must be great with a toddler – no tempting tabs to yank undone! It’s a bit strange to do a nappy up ‘backwards’ at first but you soon get used to it.

Doing the tabs up straight means no uncomfortable rubbing for the baby. Don’t be tempted to do the tabs as tight as possible – you’ll just end up with lots of leaks around the waistband as the seal will be broken at the top of the pouch.

Checking the pouch

To make sure that the pouch has a good seal around the legs you need to push it inwards so that it is right in the crease of your baby’s leg. This is definitely the most important part of getting a good fit on a gNappy – if the pouch edge is too far out you’ll struggle to avoid lots of leaks around the legs.

All done

Just give the gPant a little yank at the back (the back should be slightly higher than the front) and baby’s all set for 2-3 hours of gNappy wear.